nautilius-cd-burner/k3b gives insert a blank or rewriteable disk/no media present
cd_info reports no_disc.
booting 2.6.22-14-generic with current hardy userspace gives the same results.
hdparm -I /dev/scd0
ATAPI CD-ROM, with removable media
Model Number: PIONEER DVD+/-RW DR-K17Y
Serial Number: GBDL024510WL
Firmware Revision: 0.94
Standards:
Likely used CD-ROM ATAPI-1
Configuration:
DRQ response: 50us.
Packet size: 12 bytes
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 64.0kB
DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* Power Management feature set
* PACKET command feature set
* DEVICE_RESET command
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
I don't have windows on this machine but the CD that was not detected correctly I transferred to another machine and the cd can be written to successfully. I had no problem burning cds with gutsy using k3b.
on running cdinfo, dmesg says
Apr 29 00:17:25 alfred kernel: [ 530.131564] sr0: CDROM not ready. Make sure there is a disc in the drive.
same here. cd burning software:
nautilius- cd-burner/ k3b gives insert a blank or rewriteable disk/no media present
cd_info reports no_disc.
booting 2.6.22-14-generic with current hardy userspace gives the same results.
hdparm -I /dev/scd0
ATAPI CD-ROM, with removable media
Model Number: PIONEER DVD+/-RW DR-K17Y
Serial Number: GBDL024510WL
Firmware Revision: 0.94
Standards:
Likely used CD-ROM ATAPI-1
Configuration:
DRQ response: 50us.
Packet size: 12 bytes
Capabilities:
LBA, IORDY(can be disabled)
Buffer size: 64.0kB
DMA: mdma0 mdma1 mdma2 udma0 udma1 *udma2
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* Power Management feature set
* PACKET command feature set
* DEVICE_RESET command
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
I don't have windows on this machine but the CD that was not detected correctly I transferred to another machine and the cd can be written to successfully. I had no problem burning cds with gutsy using k3b.
on running cdinfo, dmesg says
Apr 29 00:17:25 alfred kernel: [ 530.131564] sr0: CDROM not ready. Make sure there is a disc in the drive.
(and
mark@alfred:~$ ls -l /dev/sr0
lrwxrwxrwx 1 root root 4 2008-04-28 23:55 /dev/sr0 -> scd0
)