Comment 4 for bug 284377

I can confirm this issue too, but it's unique to the access point.

I have connected successfully to dozens of other access points, but I'm trying to connect to an SMC Barricade SMC7004AWBR. The wireless connection is established, and persists (802.11b, no encryption). But I cannot draw an ipaddress.

If I try to manually configure the ip address via `ifconfig ath0 192.168.2.50`, I get this error message:
SIOCSIFADDR: No buffer space available

One thing I noticed... This access point only supports 11mbps 802.11b. The iwconfig output, though, thinks it's connected to 802.11g. Could this be part of the problem?

ath0 IEEE 802.11g ESSID:"default" Nickname:""
          Mode:Managed Frequency:2.437 GHz Access Point: 00:11:22:33:44:55
          Bit Rate:11 Mb/s Tx-Power:8 dBm Sensitivity=1/1
          Retry:off RTS thr:off Fragment thr:off
          Power Management:off
          Link Quality=60/70 Signal level=-37 dBm Noise level=-97 dBm
          Rx invalid nwid:6168 Rx invalid crypt:0 Rx invalid frag:0
          Tx excessive retries:0 Invalid misc:0 Missed beacon:0

ath0 Link encap:Ethernet HWaddr 00:55:44:33:22:11
          UP BROADCAST RUNNING MULTICAST MTU:64 Metric:1
          RX packets:51 errors:0 dropped:0 overruns:0 frame:0
          TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:8215 (8.2 KB) TX bytes:2631 (2.6 KB)

:-Dustin