This issue is present on kernel 2.6.32-24, which, as you know, is used by the LTS release.
I tested with a Dell Latitude E6410, as well as with an EEEPC. The EEEPC worked fine, but the Latitide does not show any display. I was able to install by using an alternate installer.
I attempted to use GRUB options such as video=LVDS-1:e, video=LVDS-1:d and acpi=off, with no success.
This issue is present on kernel 2.6.32-24, which, as you know, is used by the LTS release.
I tested with a Dell Latitude E6410, as well as with an EEEPC. The EEEPC worked fine, but the Latitide does not show any display. I was able to install by using an alternate installer.
I attempted to use GRUB options such as video=LVDS-1:e, video=LVDS-1:d and acpi=off, with no success.
Here's the lspci -vvnn for the Intel Card:
00:02.0 VGA compatible controller [0300]: Intel Corporation Core Processor Integrated Graphics Controller [8086:0046] (rev 12)
Capabilities: [90] Message Signalled Interrupts: Mask- 64bit- Queue=0/0 Enable+
Address: fee0a00c Data: 4199
Capabilities: [d0] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0- ,D1-,D2- ,D3hot- ,D3cold- )
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [a4] PCIe advanced features <?>
Subsystem: Dell Device [1028:040a]
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 11
Region 0: Memory at 90000000 (64-bit, non-prefetchable)
Region 2: Memory at 80000000 (64-bit, prefetchable)
Region 4: I/O ports at 70b0