[   92.744094] lp0: using parport0 (interrupt-driven).
[   94.053153] Skipping EDID probe due to cached edid
[   94.497191] Skipping EDID probe due to cached edid
[  102.750044] ata1.00: configured for UDMA/100
[  102.750056] ata1: EH complete
[  110.777086] Skipping EDID probe due to cached edid
[  111.229072] Skipping EDID probe due to cached edid
[  111.672104] Skipping EDID probe due to cached edid
[  111.689535] ata1.00: configured for UDMA/100
[  111.689543] ata1: EH complete
[  127.264095] Skipping EDID probe due to cached edid
[  140.188103] Skipping EDID probe due to cached edid
[  368.576282] usb 1-8.2: new high speed USB device using ehci_hcd and address 5
[  368.676020] scsi3 : usb-storage 1-8.2:1.0
[  369.673748] scsi 3:0:0:0: Direct-Access     USB      USB 2.0 Flash    8.07 PQ: 0 ANSI: 2
[  369.675299] sd 3:0:0:0: Attached scsi generic sg2 type 0
[  369.676915] sd 3:0:0:0: [sdb] 4014176 512-byte logical blocks: (2.05 GB/1.91 GiB)
[  369.677781] sd 3:0:0:0: [sdb] Write Protect is off
[  369.677791] sd 3:0:0:0: [sdb] Mode Sense: 03 00 00 00
[  369.677798] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[  369.681767] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[  369.681782]  sdb: sdb1
[  370.463035] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[  370.463047] sd 3:0:0:0: [sdb] Attached SCSI removable disk
[  445.564141] tg3 0000:09:00.0: eth0: Link is up at 100 Mbps, full duplex
[  445.564152] tg3 0000:09:00.0: eth0: Flow control is off for TX and off for RX
[  445.564648] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[  455.760073] eth0: no IPv6 routers present